Bryant Programmable Digital TSTATBBPQ501 Uživatelský manuál stáhnout pdf (Strana 17)

Page 16

Advanced Setup

This is normally done by the installer at initial installation.

Use these buttons to

adjust the deadband

from 1 to 6 degrees.

Use these buttons to

adjust the cycles/hour

from 2 to 6.

d=no limit (zoning)

d1=d+no compressor

lockout.

Enter advanced setup by adjusting the program switch to

SET. When the clock is flashing, press NEXT for 5 seconds.

Do not release the button until this screen appears.

Select YES to have the

backlight always on, or NO

to turn off the backlight 8

seconds after a button press.

Use these buttons to select

thermostat operation in

degrees C or F.

If degrees C is selected two presses of the Up or Down

buttons will be required to change the setpoint.

Adjust the program switch to OFF or RUN to exit

Advanced Setup.

L I

Yes

Step only

appears

if connect-

ed to 24

volt power

1 2 ... 12 13 14 15 16 17 18 19 20 21

Žádné komentáře

Bryant Programmable Digital TSTATBBPQ501 Uživatelský manuál Strana 17