Bryant T6-PRH Manuál s instrukcemi stáhnout pdf (Strana 4)

Rh terminal. Connect R from the outdoor unit to the Rc terminal. Then, break

jumper on the circuit board. The W and G signals are taken from the Rh power

and the Y and O signals are taken from the Rc power. If thermostat has been

installed in a two--transformer application that is later changed to a

single--transformer installation, installer must install a field supplied jumper

between Rc and Rh. Depending on the installation, up to 14 wires may be

required. Installation as two-- piece unit is recommended. Only 2 wires are

required for connection between Display Module and Equipment Control

Module.

A07052

Fig. 1 -- PCB Breakout Jumper

Models

There are programmable and non --programmable models for all applications.

They can be configured for AC or HP, 1--or 2--speed compressor, and for Hybrid

Heatt installations, allowing it to be used in place of all Bryant thermostats.

Programmable thermostats may be configured as non--programmable if user

desires.

1 2 3 4 5 6 7 8 9 ... 75 76

Žádné komentáře

Bryant T6-PRH Manuál s instrukcemi Strana 4