Bryant ASPAS1BBA007 Průvodce řešením problémů stáhnout pdf (Strana 20)

20

7. Remove the knockout in the lower

right corner of the external connection

box. From the rear of the connection

box, feed wires & 4-pin plug into box.

Slip the lock nut over the wires and

plug and tighten securely onto conduit

coupling. Match and connect wires by

color to lugs with existing wires. Snap

together the 4-pin connector. Loosen

the nut from the grounding lug and

attach ground wire (green) from the

conduit. Reinstall the nut and tighten.

Mount external connection box over

pre-drilled hole. Seal around the

conduit with insulation and silicone

caulk.

8. Install the automatic transfer switch

within 1' of your main electrical

distribution panel. Secure excess

conduit to walls and/or ceiling.

Switch off all circuit breakers

in the emergency load center.

9. In this step you will be relocating

circuits to be powered by the

generator from your main panel to

the emergency load center. After

removing the proper size knockout,

remove the threaded lock nut from

connector and feed all wires from 2’

conduit into your main electrical

distribution panel. Slip the lock nut

over wires from the inside of the

main panel and tighten onto

connector securely.

GROUND SCREW

KNOCK

OUT

1’

The outer diameter of

the threaded end is:

15/16” (7 & 12 kW) or

1-3/8” (15 kW)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře